IPA 412 T
4-channel DSP Installation Amplifier 4 x 120 W @ 4 Ohm / 70V/100V
SPECIFICATIONS
-Audio Channels 4
-Operating voltage Wide Range SMPS with PFC (power factor control)
-Indicators Front Panel: "PROT", "LIMIT", "SIG", "BRIDGE" and Mute Symbol LED´s. Power On/ Standby LED, Rear Panel: 4x Input Clip LED´s, Remote Lock LED (Red)
-Controls Element Back Panel "BRG“ (Bridge), "PAR“ (Parallel), "ST“ (Stereo), Amplifier Channel Mode, Low-Z and High-Z switches (paired), Output Volume potentiometers, Preset A and B switches, Remote Lock, Remote ON/OFF, Remote-Mode, Standby On/Off
-Inputs 4x Balanced Line Inputs, Remote Bus Audio Input
-Input connectors 6-pin Terminal Block Pitch 3.81mm, Remote IN/OUT RJ45, Service Micro USB Type-B
-Cooling front to rear/side airflow, Passive + 2-zone temperature controlled active cooling
-Operating voltage 100 V AC - 240 V AC, 50 - 60 Hz
-Width 483 mm
-Height 44.5 mm
-Depth 425 mm
-Optional accessories 19" L mounting rails ( AH - 876TL )
-Weight 8,7 kg
Amplifier Output Specifications, all outputs driven and loaded
-Rated ouput power (1kHz @ 4 Ohms) 4 x 120 W (1,5 Seconds Sine Burst)
-Rated ouput power (1kHz @ 8 Ohms) 4 x 60 W (1.5 Seconds Sine Burst)
-Rated ouput power (1kHz @ 16 Ohms) 4 x 30 W (1,5 Seconds Sine Burst)
-Rated ouput power (1kHz @ 8 Ohms, bridged) 2 x 235W (1,5 Seconds Sine Burst)
-4 x 240W, Transformer Coupled Output 4 x 120W, Transformer Coupled Output
-Protection circuits Audio Limiter, DC, HF Protect, HPF (High-Z), short circuit, temperature, thermal overload
-Minimum load impedance per channel 4 ohms Single-Ended, 8 ohms Bridge
Performance specifications
-Nominal input sensitivity+5 dBu (Sine 1 kHz, Gain max)
-Nominal input clipping19 dBu (Sine 1kHz)
-THD + N< 0,03 % (Low-Z SPK OUT, +18 dBu, 20 Hz – 20 kHz)
-Frequency response 18 Hz – 22 kHz (Low-Z OUT, -3 dB), 50 Hz – 23 kHz (High-Z OUT, -3 dB)
-Signal-to-noise ratio >105 dB (Low-Z SPK OUT, CH Gain Center (0 dB), 20 kHz BW, a-weighted)
-Crosstalk 83 dB @ 1 kHz